メインコンテンツにスキップ

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

iPhone 6 Stuck Itunes Logo (Error -1)

Hye i got an IPhone 6 sent in to me for repair. It stuck on Itunes logo and when I do recovery it showing Error -1. Before this the phone having a NO SERVICE issue, and then when the customer do recovery on itunes, it begin to stuck on itunes logo. When I hunt around the baseband area through microscope, I see two caps are missing (C4103/C4104) . I believe that this two caps are responsible for WTR_TX_OUT line.

So my question is, can I just make a jumper on this two lines without solder a new caps ?

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

You can't jumper capacitors, that's not how they work. These particular caps are used inline, that means they are meant to filter out any DC component to the AC signal going into U_2GPARF. These are pretty standard capacitors and easy to source as new or from donor boards.

Do you believe these capacitors were removed by another tech or were physically damaged? Check closely to see if anything else is missing. As for Error 1, I would reball the baseband CPU.

このアンサーは役に立ちましたか?

スコア 2

2 件のコメント:

I dont think the caps is been removed. Maybe because of the physical damaged. So what about the BB PMIC ? Do I need to reball ?

さんによる

Start with just the BB CPU.

さんによる

コメントを追加

回答を追加する

Azim WHITE さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 70