修理を始めるには コミュニティ ストア

Repair guides and support for LED, LCD, HD and other Vizio TVs.

931回答 すべてを表示

オプション

D55u-d1 Gets logo then powers off.

So of course my Vizio TV is out of warranty. Recently I have an issue where the logo will display but after 10 seconds it powers off. Being out of warranty I replaced the main board myself to no avail. Before I waste more money solving this problem does anyone have any ideas as to what would cause this problem?

All the boards look good, I don't see any signs of blown capacitors, I'm just wondering what my next step should be, replace power board or replace t-con board.

Vizio tells me it can't be a firmware issue nor will they release the firmware to me.

Any ideas?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0

1件のコメント:

After talking to tech support from their third party company it sounds like a screen issue....if that's the case it's not cost effective to fix. Anyone else dealt with a power issue on screen itself?

さんによる

コメントを追加

3件の回答

フィルタ：
参考になった順 新しい順 古い順

オプション

If you change the logicboard , then check if there is any other board inside, then check for the backlight if it works.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

3 件のコメント:

Backlight works I can see it power on with the back panel open. There are 3 other boards, but I found a total repair kit for $70 that includes all the boards, so I just bought it. I'll regut the whole thing and that should solve any issues I'm having.

Thanks,

Dan

さんによる

Alright, if you change it all and not work there is no other way

さんによる

lol that would be my luck!! Vizio support is no help.....they make it sound like only absolute trained professionals should replace these parts.....sorry Vizio your LED tv's are much easier to fix than the 5 DLP's i've brought back to life!

さんによる

コメントを追加

オプション

Regutted entire TV, nothing solved the problem....i'm believing it's a firmware issue yet no one will release the firmware to me....anyone happen to know where I could get it?

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

1件のコメント:

Did you figure out the solution?

さんによる

コメントを追加

オプション

You have a bad EEPROM in the main board, its what sends the start boot to the CPU, its a common failure, and a $10 part but a little tricky to replace unless you are real good at soldering, its only a 8 pin chip but very small, a replacement main board will also fix the issue but that board isn’t cheap

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

1件のコメント:

Do you know the part number?

さんによる

コメントを追加

回答を追加する

Dan Ritchie さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 11

今までの合計 1,140