Bit won't come out of the chuck.

Question

RIDGID R84015 X2

The RIDGID R84015 X2 is an 18v, 1/2 inch chuck, cordless drill.

6回答すべてを表示

Joel Silva @joelsilva

評価: 13

1

投稿日: 2011年3月15日

オプション

Bit won't come out of the chuck.

I used my drill today and I went to drill a into a piece of brick and the bit went back into the drill somehow. I can open and close the chuck but the drill bit will not come out. When I push on the end of the chuck it goes into the drill, it has a lot of movement.

I tried everything to try and get the drill bit out, nothing works, I don't understand how it could get stuck in the drill when I can still open and close the teeth to the chuck. Thanks.

Joel

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 1

コメントを追加

3件の回答

ベストアンサー

mayer @mayer

評価: 685.3千

MacHale Enterprises

3.4千

1.1千

2.6千

投稿日: 2011年3月15日

オプション

Open the chuck as wide as it will go. Hold it with the opening pointing down and tap the chuck with a small hammer till you can either grasp the bit with a pair of needle nose pliers or it falls out.

このアンサーは役に立ちましたか？

はいいいえ

スコア 4

コメントを追加

chris @chris18752 評価: 1 · Answer 1 · 2012-10-10T15:28:53-07:00

chris @chris18752

評価: 1

投稿日: 2012年10月10日

オプション

The bit you were using got jammed into screw that holds your chuck in place.

このアンサーは役に立ちましたか？

はいいいえ

スコア 0

コメントを追加

maineman1950 @maineman1950 評価: 1 · Answer 2 · 2013-09-20T07:03:41-07:00

maineman1950 @maineman1950

評価: 1

投稿日: 2013年9月20日

オプション

If you can still grsp the end of the drill bit with a bair of plyers bring the jaws of the chuck to the edge. Place a washer over the bit. Clamp a pair of vise grips on the bit and then turn the chuck out. The washer is just to protect the jaws. you might need to turn the chuck with a pair of channel locks.

このアンサーは役に立ちましたか？

はいいいえ

スコア 0

コメントを追加

RIDGID R84015 X2

Bit won't come out of the chuck.

3件の回答

回答を追加する