オプション

Has anyone had a problem with the Digitizer Adhearing?

I’m having a problem with the replacement digitizer adhearing along the home button side. (bottom) The digitizer cable seems to be pushing up on the digitizer causing the adhesive not to fully cure to the housing. Any suggestions? I’ve tried reheating and letting something sit on it overnight to hope that it sticks. It’s almost as if it needs thicker adhesive. Any recommendations at this point would be greatly appreciated.

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 0

1件のコメント

thanks! i’m going to pick one of those up and finish the silly thing up.

Eric White さんによる2018年2月21日

コメントを追加

投稿日: 2018年2月21日

オプション

There's not a lot of adhesive on the bottom side of the digitizer and a lot of stuff underneath it. You have to make sure the flexes are properly sitting within the device as even the tiniest amount of pressure will eventually cause the adhesive to let go of the digitizer.

The actual adhesive matters also. Was the adhesive initialled or did you apply some yourself? I find that the pre-installed adhesive is generally low quality and doesn't stick as well as a high quality adhesive, such as the Tesa tape you can find here on iFixit or pre-cut 3M tape from Bowler-Tech, which is what I use ( I remove the pre-installed tape first).

このアンサーは役に立ちましたか？

はいいいえ

スコア 1

コメントを追加

iPad Mini 3 Wi-Fiモデル

Has anyone had a problem with the Digitizer Adhearing?

1 件の回答

回答を追加する