メインコンテンツにスキップ

2015年9月25日にAppleから発売されたiPhone 6Sの修理情報とガイドです。モデル A1688、A1633。

2682回答 すべてを表示

Screen not turning on

After screen replacement my screen won’t turn on. The phone was switched of and the repair was done. When the new screen wasn’t working I tried putting the old cracked one back on it but it didn’t work either. I’ve done lots of screen replacements but have never come across this problem. I have tried everything but cannot find any fixed please help.

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

I’ve tried using a flashlight too see the screen but I cannot see anything but the phone is turning on because I can hear the noise from charging the phone and it vibrates when putting ot on silent

さんによる

コメントを追加

1 件の回答

ベストアンサー

Did you forget to unplug the battery?

Backlight failure is a very common issue on the 6s models in particular because of the 4V pin and the ground pin on the LCD connector being next to each other can can be shorted easily when connecting or disconnecting the screen with the battery plugged in (even with the phone and screen turned off).

Usually you will see a puff of smoke near the screen connector when this occurs.

To confirm backlight failure, turn the phone off and use a flashlight to see if you can see a dim apple logo on the middle of the screen, additionally you could connect the iPhone to a computer and open up iTunes to see if the phone successfully boots up and is detected by iTunes.

To get backlight circuit fixed, that requires someone to do micro-soldering on the phone (basically repairing the backlight circuit and components on the logic board).

I would estimate about $80-$150 for the job to be done.

このアンサーは役に立ちましたか?

スコア 2

3 件のコメント:

I’ve tried using a flashlight too see the screen but I cannot see anything but the phone is turning on because I can hear the noise from charging the phone and it vibrates when putting ot on silent

さんによる

Then it's either a faulty screen or micro-soldering need to be done on the board at least.

TL:DR - Phone most likely needs to be looked at someone that does micro-soldering to troubleshoot no display / backlight issue if multiple screens have been tested already on the phone.

さんによる

Alright okay, thanks.

さんによる

コメントを追加

回答を追加する

Haris さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 90