メインコンテンツにスキップ

モデル番号A1311 / Mid 2010 / 3.06 & 3.2 GHz Core i3もしくは3.6 GHz Core i5プロセッサ

320の回答 すべて表示

How to detach LCD thermal sensor cable?

I’m dismantling my 21.5” iMac EMC 2389, to replace the hard drive.

I have been unable to detach the LCD thermal sensor cable from its socket, it’s nowhere near as easy as it appears on the IFIXIT video and there is no mention in the notes about it being very difficult.

Is there a trick or something I am missing?

回答がありました! View the answer 同じ問題があります

この質問は役に立ちましたか?

スコア 2
コメントを追加

2回答

選択されたソリューション

Its a snap fit but as the system ages the plastic looses some of its flex so they do get thougher to disconnect.

You'll likely need a couple of these: Spudger then carefully pry from each side equal pressure. Don't lift up! You want the pressure the go in parallel with the logic board.

Spudger画像

製品

Spudger

$3.99

この回答は役に立ちましたか?

スコア 3

コメント:

Many thanks Dan. "Spudgers" are the go ... although locally (Adelaide, South Australia) they didn't know the term, and the packaging describes them as a "Plastic prying tool". Ended up buying an "iPHONE REPAIR KIT".

による

yes, very difficult to detach the connector. I pulled on the wires and the wires came out of the connector, damaging the cable. I noticed the other end of the cable is just adhesive to the LCD screen. So, it easier to just detach the adhesive end of the cable from the LCD screen.

による

コメントを追加

Sounds good but how do you plug it in on a pre owned imac that someone obviously had trouble removing it before?

この回答は役に立ちましたか?

スコア 0

コメント:

Post a couple of pics so we can see what you are facing Adding images to an existing answer

による

OMG! I was looking as to how it's attached to the lcd on an old screen. I thought i could just unglue (if thats a word?) it, then reattach it after i plug in the other end. Thought it might damage the sensor. Thanks for the answer. Going to try it right now. Lynn

による

コメントを追加

回答を追加する

Graeme さん、ありがとうございました!
統計データを表示:

過去 24時間: 1

過去 7 日: 7

過去 30 日: 29

今までの合計 483