修理を始めるには コミュニティ ストア

モデル番号A1136/30、60、80GBハードドライブ/ブラックまたは白のプラスチックフロント

797回答 すべてを表示

オプション

Why is it my click wheel gets stuck under the front panel?

i ordered front panel, rear panel, replacement battery, headphone jack and hold switch and click wheel (with electronics) from i fixit and i put it all together, then once its all together i notice that the click wheel seems too be kinda stuck under the front panel on the left side because when i press the previous song button it makes a loud click noise instead of the usual quiet noise, i even took it apart and put it together 3-4 times, same everytime, what could it be? did they sell me a part thats not "Exact Fit", and also i want to "Stick" the battery to the rear panel along with all the ribbon cables, can i use krazy glue or what?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Check on the click wheel there is a metal frame the is made to provide some of the spring action you can adjust it by bending it a little and that will enable you to adjust the wheel inside the front plate. Also of course you made sure that the wheel is line up with the notches in the front plate. I would not use crazy glue for the battery. Use another liquid glues to gets sticky but eventually can be removed. Any liquid glue would be better than crazy glue. PITA to remove at a later time if you ever have to. Good luck and I hope this helps.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

4 件のコメント:

which glues do u reccomend/ have used in the past

さんによる

I use the department store " rubber cement" It sticks very well but it does allow me to remove the component later on if I have to. I do not know where you are but I use the Walmart brand :)

さんによる

im in NY, and ok thanks alot for the "rubber cement" ill go get some tomorrow, and what kind of metal frame, i opened it and really did not see any, metal frame besides the logic board frame

さんによる

underneath your click wheel you should have a metal piece that fits the grooves of the front plate. Sometimes they are to high and push the wheel through the front plate and make it look uneven.I try to attach a pic to my original answer. You see that black looking thing? See if you can either bend it up or down to make your click wheel fit better

さんによる

コメントを追加

回答を追加する

BrianTheFixit さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 810