メインコンテンツにスキップ

2.3L 4cyl or 3.0L V6, 6th Generation

425回答 すべてを表示

Where is the ignition coil?

Hello,

I think I might have the case of misfiring for my Honda Accord 4 cyclinders LX. My plan is to change out the ignition coil; yet I'm unsure of its position.

If any of you guru could help me in pinpointing out where it is, that would be great.

Sincerely.

Update (05/26/2017)

1999 Honda Accord LX 4 cyclinders.

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
2 件のコメント

I have a Honda Accord,a 1999 LX 2.3 litre Canadian bought.On real damp days it won't start.The plugs and wires were reinstalled 100km ago.Is it time for a change or is it my coil.

She's fine if you give her an hour and let the water evaporate and then will drive fine again until the next demo day.

さんによる

I believe it is integrated with the distributor

さんによる

コメントを追加

3件の回答

ベストアンサー

your coil, pn 30500-PAA-A01, is located inside the distributor, under the cap.

Block Image

このアンサーは役に立ちましたか?

スコア 4
コメントを追加

Before going to the expense of replacing the coil it may be a good idea to get the codes read and find out for sure what the problem is .A misfire is not usually cause by a coil unless you have individual coils . This is an excellent video for diagnosing misfires in a honda

https://www.youtube.com/watch?v=m2fubKkv...

Hope this helps

このアンサーは役に立ちましたか?

スコア 3

1件のコメント:

I agree with Jim, do not replace coil prior to other checks for misfire, Good diagnosing video link above in his answer.

さんによる

コメントを追加

I have a 99 Honda accord lx and it will run fine for about half hour and stall out and won't start back up for about a half hour

このアンサーは役に立ちましたか?

スコア 0

3 件のコメント:

check the main relay and the fuel pump. one of them is most likely getting to hot, probably from a high internal resistance. once it has a chance to cool down it will work for a while until the heat builds up again.

さんによる

The main relay controls the fuel pump, it is a normal wear and tear item but it can be resoldered to last another 10 years, just resolder the larger of the solder pads for the relays themselves, there are 2 of them, works every time IF THIS IS YOUR PROBLEM. By cooling down the distributor on the aluminum part of the body with a water hose may lessen the 30 minute cool down period to see if that is it or your CKP sensor or CMP sensor may also be overheating can be cooled down to troubleshoot. THis goes for any item that can be cooled down but the items listed are suspect.

さんによる

My main relay switch that I purchased online was very cheap. All I did was plug it in underneath the steering column, and my car stopped dying on me. It took a long time to figure out the problem, in the process I killed my car battery.

さんによる

コメントを追加

回答を追加する

Hien Nguyen さん、ありがとうございました!
統計データ:

過去 24時間: 3

過去 7 日: 31

過去 30 日: 173

今までの合計 12,512