Hello all. I recently replaced my screen on my 6 plus. Just a week ago it started going black and would take a few minutes for the screen to work again. Now it won't come on. The funny part is when I open the phone up the screen works and as soon as I snap it back into the frame the screen goes black again. What could this be?
評価: 14
3
My first guess is that a cable on your new display is unreliable: As the cable flexes when you close up your iPhone, one or more conductors in the cable are losing their connection.
このアンサーは役に立ちましたか？
Looks like bad cable. Would it harm my phone if I keep using it. Should I leave it off until I get it replaced.
It could, it may end up blowing up a backlight filter causing display but no backlight (dim display) ending up in a micro soldering job needing to be done (backlight filter would need to be replaced).
I would replace the display assembly with a new one. I would not use the phone until a new assembly is installed.
i had this on 5s and 6plus, so when open and usable, restore on apple by pressing on button, and home same time until itunes says this phone has a problem….restore it….just as a first attempt at repair
still only works when i opened it up…so pressed on logic board a few times…and in settings , screen lock as NEVER,
screen time off, all other settings off, no fingerprint, no apple ID, only wifi….closed it up and stayed OK
was it me pressing the logic board?…
if all fails can use with screen slightly open I suppose, permanently fixed somehow away from the body?
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 2
今までの合計 140
1件のコメント
I also noticed the cable piece with the brass contacts that touches the metal cover on the digitizer when the corner is pressed against the metal piece the screen dies
Charles inman さんによる