メインコンテンツにスキップ

Samsung Galaxy Note IIは、大型ディスプレイと一体型自己記憶スタイラス用に最適化されたソフトウェアを組み合わせたスマートフォンでとして知られています。

211回答 すべてを表示

After replaceing glass - touch doesn't work very well

Hi,

I've replaced my cracked glass on the Galaxy Note II and everything works well.

However, I can see that the glass is a bit higher than the metal body in the lower part (near the buttons) and the touch isn't working very well in these areas. If I press the glass down hard, it stays there and the touch is working fine then, but after a few minutes it rises up again and the touch doesn't work well (still works, but stutters).

I think it might be because some adhesive was left on the adhesive tape surrounding the body... or maybe while removing the glass, I pulled the LCD up too much...

Do I need to redo the whole procedure?

I even tried keeping the phone under a heavy weight throughout the night but even that didn't work.

Please help!

Amit

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア -1
コメントを追加

1 件の回答

最も参考になった回答

This is most likely due to the previous old adhesive for the old glass not being cleaned on the frame properly and/or newly applied adhesive was too thick causing the touch to be too high and not work properly unless pressed down hard.

I think you need to clean the adhesive very well on the frame then put new adhesive on again. I haven't done glass replacement on the Samsung Galaxy Note II so there may be other things you need to do to get it working reliably.

このアンサーは役に立ちましたか?

スコア 1

2 件のコメント:

Thanks for replying!

So do I need to buy a new glass? If I remove the glass and I want to put it on again, where do I get new adhesive from?

さんによる

コメントを追加

回答を追加する

Amit さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 64