評価: 13
1
I am currently removing the heat shields from an iphone 6s to perform liquid damage cleanup. I am having trouble removing the larger heat shield that is right next to the battery connector. I have already mixed low melting solder with the solder that is holding the shield down, but I am still not able to get it to break free.
Any tips or help on how to remove this shield without causing damage to the board would be appreciated.
評価: 4千
9
5
4
Use a hot air gun.
Normally i use a hot air gun. 250 degrees C
hold the hot air gun vertically above the board. point it on the shield and do like a circular motion on top of it. after you do that for a bit use a tweezer and try to take the shield off every few secs. hope this helps
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 231
