評価: 102.5千
18
191
304
this should help
このアンサーは役に立ちましたか？
Jim - That's what says is missing. Go back to your link FULLY and read it all. See Dan's answer.
@mayer Sorry didn't realize there was a separate serial number for the hinge
@beaverme this video shows how to remove the the hing and at 47 seconds in you can see the serial number on the hinge assembly itself
https://www.youtube.com/watch?v=e4kHw-5m...
sorry for the earlier confusion
Nice research Jim
Thank you @jimfixer. The video shows an iMac but it seems reasonable to assume that the Thunderbolt Display is marked is the same place. Unfortunately the hinge on my Thunderbolt Display does not have that label.
評価: 479.3千
35
329
971
The hinge is where the foot connects to the display. You'll need to remove the foot to see it. Its' a real pain to get to.
このアンサーは役に立ちましたか？
Removing the stand wasn't too tricky but I cannot see a label on the visible part of the hinge mechanism.
mmm .... Was it a little warm when you bought it ;-)
I'm wondering if the s/n shows up under the hardware profile for the display. That's the only other place I can think off other than pulling off the display assembly off and looking on the logic board.
過去 24時間: 0
過去 7 日: 0
過去 30 日: 1
今までの合計 575
2 件のコメント
Turn the display on its back then look at the bottom of the foot
Dan さんによる
Thanks Dan. I know that the serial number is printed on the bottom of the foot. My question is about the hinge mechanism.
Lee さんによる