修理を始めるには コミュニティ ストア

モデル番号はA1347番で2.4もしくは2.66 GHz Core 2 デュオプロセッサが搭載されています。

76回答 すべてを表示

オプション

Mac Mini 2010, fan full speed, but reads 0 rpm

Hiya,

Second hand Mac Mini with a problem here. Fan is going full speed (I can hear it loud and clear), but reads 0 RPM.

Software, like Macs Fan Control or smcFancontrol to lower the speed won't work (can't go lower then 0 RPM, so seems obvious).

I'm missing 2 temperature sensors (the ones attached to the HD), which are coming in next week, however in my common sense that should not be the reason for tools to read the fan speed at 0 RPM.

Am i missing a problem here somewhere ? Another loose connector or missing sensor or something ?

SMC and PRAM reset will not work. Tried it. Sensor to Superdrive works fine.

Any idea ?

Cheers!

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

The issue is the tach inside the fan unit and how it communicates to SMC. This is were the connection of the fans connector could be backwards, or the logic board got damaged in the process of taking off the connector. There is a small resistor just behind the connector that some poeple pop off in the process of pulling the connection.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

2 件のコメント:

I will have a look at the board if the resistor got damaged, but i think it was fine. Otherwise i will order a new fan, see if that solves the problem.

Thank you so much for your replies so far, really appreciated!

さんによる

I have the same problem - 0 rpm readings yet the fan spinning at full speed.

I noticed the technician who swapped my hdd for an ssd popped the resistor you're talking about. Anything I can do besides replacing the logic board...?

さんによる

コメントを追加
最も参考になった回答

オプション

The sensors are what allow the temperature to be read. Without those the machine will most defiantly do as you have described. That is why you hear the noise from the fan but cant get a appropriate reading because the sensor is missing. Do you know if the hardware is all original?

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

6 件のコメント:

Hi Stuntman,

Thank you for replying.

Yes of course no temperature without the sensor and lots of fan noise, but why does the fan read 0 RPM? Doesn't make sense to me.

All hardware is original.

さんによる

You may have flipped the connector around. Also the fans tachometer unit maybe bad.

さんによる

When you replace the HD don't forget to remove the sensor from the old drive and reconnect it to the new one.

さんによる

2 Sensors connected and hardware test nog gives no more errors. However still full speed fan but reading 0 rpm :(

さんによる

You may have connected the cable connector the wrong way.

さんによる

1以上のコメントを表示

コメントを追加

回答を追加する

mschats さん、ありがとうございました！
統計データ:

過去 24時間: 1

過去 7 日: 1

過去 30 日: 5

今までの合計 2,009