修理を始めるには コミュニティ ストア

2012年9月12日に発表されたApple社による6番目となる iPhone。このデバイスの修理方法は前モデルと類似しており、スクリュードライバーと開封工具が必要です。GSMかCDMA方式、16/32/64 GB。 本体色は黒と白。

2522回答 すべてを表示

オプション

Backlight works, but there is no display.

Hello,

I have an iPhone that will not display an image, but the backlight turns on. After inspecting the area around the lcd connector I determined that the L44 display filter was missing. I replaced it with one from an old iPhone 5, but nothing has changed. The phone is still turning on but not displaying an image. When it is plugged into a charger it just beeps periodically. I have tried many different LCD's so I know that is not the problem. I will include a picture of L44 that I replaced.

Block Image

. This was my first time replacing something this small, so I don't know how good of a job I did. Does anyone have any suggestions for me?

Thanks

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

After replacing a Filter you should always check if you have done a proper job with a simple multimeter. In this case connect the probes of your MM according to the picture I added. It should beep when you connect them. If they don't that means you do not have continuity and the filter mostlikely is bad or not soldered properly. 1 Filter = 2 measurements (each color represents 1 measurement)

Block Image

While you at it: check the other filters too.

Why was the filter missing ? Waterdamaged board ? ripped of ? maybe there are more components missing the the lcd connector ?

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

1件のコメント:

hey i suffer the same problem backlight coming and no image.. and i checked my diodes they give error so i removed them and attached the jumper.. but still no image on display... i also tried new lcd but nthng is there

さんによる

コメントを追加

回答を追加する

mSuj さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 1,564