screen replacement worked but won't detect finger touch

Question

iPod Touch 第4世代

モデル番号 A1367/ 8, 16, 32 もしくは64 GB容量

914回答すべてを表示

締切られた回答

josephfchadwick @josephfchadwick

評価: 1

投稿日: 2014年12月31日

オプション

screen replacement worked but won't detect finger touch

I have replaced the screen on the ipod 4 and the screen works and it powers off and the sound works and voice control works, however, it won't detect my finger to either 1) swipe 2) put in a passcode or 3) go into the camera, it will play music through voice control though. I want to be able to back it up in itunes but itunes needs the passcode and that's the major issue I have, i want to be able to back it up.

Second major question--how can I back it up in itunes without a passcode or with the passcode from the computer since I can't put the passcode into the ipod?

この質問に回答する同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 0

コメントを追加

2件の回答

con @con82159 評価: 37.6千 IRepair iphones 22 51 42 · Answer 1 · 2014-12-31T14:39:34-07:00

最も参考になった回答

con @con82159

評価: 37.6千

IRepair iphones

22

51

42

投稿日: 2014年12月31日

オプション

Make sure the digitzer cable is seeded 100% ifs difficult because of the position of it under the logicboard once you think it's in correct push down on the logicboard directly above were cable is located and it will clip into place

このアンサーは役に立ちましたか？

はいいいえ

スコア 1

2 件のコメント:

awesome, i took it apart again and focused on the digitizer and now i get a white screen. I might have kinked the cable a bit but it's not torn.

is there a way to put in the passcode from the itunes computer so i can back it up?

josephfchadwick さんによる2014年12月31日

I would try disconnecting then re-seating the connectors, then hard re-booting your iPod before just throwing the old screen away.

If you're lucky and it works again, make sure to fold the flat cable in a zig-zag manner (2 or 3 folds, can't remember for sure) so that it sites between (the edge of the iPod) from top, and (the upper edge of the metal plate) from bottom; otherwise, it get squeezed between he LCD and the metal plate underneath it when gluing the assembly back in place..

Rany さんによる2015年1月1日

コメントを追加