評価: 143
3
4
How can I remove the hold down nails {to be replace with insulated screws[from the corrugated metal roof
without damaging the metal roof? is there a nail puller
that pulles straight up and not pried up.
この質問は役に立ちましたか？
評価: 479.3千
35
329
971
You may need to fashion a block of wood that conforms to the metal roof to spread the pressure of the hammer claw/crow bar base as you pry the nail.
I took two blocks of wood and two pieces of 1/4 steel placed across as short a distance as I could between the blocks. Then resting the hammer on the metal bar pulling the nails.
In my case I had raised over-lapping seams. If you have corrugated roofing that will be harder depending on where they nail it down.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 1
過去 30 日: 11
今までの合計 7,677
