評価: 1
1
Sometimes the drive is not recognized after it is plugged in. Even though you can feel the disk rotating, the light does not glow nor is the drive recognized by your computer. This behaviour erratic.
この質問は役に立ちましたか？
評価: 78.2千
384
96
162
I would suspect that the drive is not receiving enough power at times. Does this always happen at the same USB connection? If so does moving it to another USB port allow it to work properly? Of course if the drive is powered by external means I would worry the drive may be failing. Ralph
このアンサーは役に立ちましたか？
Once this has happened you can have Master Directory damage that will cause continued problems. Use Disk Utility to repair directory damage. N.
+ agreed, different ports offer different power levels
評価: 457
5
1
2
You may check your Energy setting for 'Put Drives to Sleep' and ensure that is off.
You could have a bed drive (even if new). Look, if a company makes a million of something there is a good chance that at least one of them is bad. I have a FireWire drive that is externally powered and sometimes it just stops. I think it is the drive itself.
このアンサーは役に立ちましたか？
評価: 13
1
The energy setting just made the difference for me. I was using this as a bootable volume for a new snow leopard computer, and the default settings for both battery and power adapter were turning off the drive whenever I tried to use it to boot. Helpful tip. Thanks.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 1,296
1件のコメント
Once this has happened it can cause master directory damagethat will increase problems until the drive is hosed. Use Disk Utility->repair disk for directory damage, back up your data. N.
originalmachead さんによる