評価: 25
1
1
My calculator was working fine until this morning during a test the screen turned super faint. It didn't die because I can still (almost) see the numbers.
The batteries are new but I tried other ones just in case.
Any ideas?
この質問は役に立ちましたか？
評価: 782.1千
1.1千
893
2.3千
Janessa, try to adjust the brightness. The contrast on your screen might have reset to dark. You can adjust it by pressing "2nd" and the "up" arrow (or "2nd" and "down" arrow) repeatedly. Hope this helps.
このアンサーは役に立ちましたか？
Holy $@$* you just saved my life
thank you so much
Thanks! That worked great
Tried changing brightness/contrast, but the screen is still faint, I am hardly able to see the numerics on it.
Any other remedy?
even unable to find a service centre in Mumbai
Just reset the calculator!!
評価: 479.2千
35
329
971
Check the battery contacts to see if you have some corrosion on them.
Did you spill anything or stress it with some weight resting on it?
このアンサーは役に立ちましたか？
Tried removing and cleaning the battery contacts, but the screen is still faint, I am hardly able to see the numerics on it. Any other remedy?
Any other remedy?
even unable to find a service centre in Mumbai
過去 24時間: 2
過去 7 日: 34
過去 30 日: 155
今までの合計 24,276
1件のコメント
My TI83 has a similar problem. When I switch ON, the screen has vertical lines where the pixels don't come on. The calculator works fine except for the vertical blank lines. When I use the calculator for some minutes, some of the vertical blanks become functional again. But there are always one or two lines that remain. Some thermal-related problem?
T J Joseph さんによる