メインコンテンツにスキップ

2012年11月2日に発売された第四世代のiPadです。16、32、64GBモデルがあります。モデル番号はA1458です。

217回答 すべてを表示

I mistook the home button ribbon cable connector

I have broken off the square 5 wire connector next to the home button ribbon cable, and all the soldered leads are no longer attached. How to repair?

I have attached two pictures from the guide. I mistook the connector as the picture was a little too small to see, only after "prying up the flap" did I discover I pried up the soldered connector.

Is this repairable or have I junked my new iPad 4th ten pride and joy?

Here are pictures where the connector is shown as right next to the cable connector…

Block Image

Block Image

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 1
コメントを追加

1 件の回答

The connector can be replaced but the leads may need to be re-routed. It is a difficult repair, you could ruin it further if not done carefully

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

I just found a repair service who will solder a new connector to my logic board for $50 plus shipping. Will advise once I have it back in house.

さんによる

コメントを追加

回答を追加する

Al Taylor さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 425