評価: 1
1
I had a cracked LCD screen. Prior to disconnecting the LCD cables the backlight worked fine. I replaced the screen but since then the backlight doesn't work. I confirmed the backlight cable and LVDS cable are securely attached. What are the possible causes?
この質問は役に立ちましたか？
評価: 116.3千
66
68
359
Blown fuse/controller for the backlight. This is not a DIY repair unless you work with electronic component replacement on a regular basis. Logic board soldering requires special tools, solder & lots and lots of practice.
Follow the tag at right for more information.
If this answer is acceptable please remember to return and mark it.
このアンサーは役に立ちましたか？
Is there a way to confirm this visually before taking it in?
Kimberly, if you have a multimeter you could check the fuse for continuity.
Where is the fuse?? Location
評価: 13
1
Check your backlight cable ... I installed mine the way the cable was positioned and best I got was black screen with faint apple symbol .....
But turns out I had it in backwards ... Was very awkward to flip cable and install bit that was it , try that just for !@#$% and giggles
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 382
1件のコメント
Did u get this fixed ??
Gregg Thomson さんによる