メインコンテンツにスキップ

iPhoneの5代目となるiPhone 4S。このデバイスの修理は比較的簡単で、スクリュードライバー、開口ツールと忍耐が必要です。GSM/CDMA / 16, 32, 64 GB / 白と黒

2189回答 すべてを表示
締切られた回答

Do iPhones have built in overload protection?

I built a charger with a 5v regulator and hard wired it to the regulator. The regulator shorted out and killed my phone, it wont charge anymore. If I turn it on it runs for maybe one minute and then shuts down. Any way, my question is if I replace the dock connector will it fix the problem, or do I just need to buy a new phone?

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

ベストアンサー

John Laney, there is a reversed voltage protection, but I can not see an overload protection. I would start by replacing the dock connector. While you do that, visually check your components on the board. Look for any signs of burned, charred or missing components. Be aware that if you have to perform any repair on your board, it will involve very small components that require good tools and great skills to repair.

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

Just replaced the dock connector, didn't fix the problem. I also looked for signs of charring on the board, none to be found on the visible side. I'm afraide I just need to buy a new phone :(

Anyway thanks for the advice.

このアンサーは役に立ちましたか?

スコア 0

2 件のコメント:

Replace battery.

さんによる

did that too, didn't affect it. Bought a new 5s. Thanks for the help anyway.

さんによる

コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 707