The iPhone was working properly, had never been opened and all parts were OEM. I was using it, then i set it down for a few minutes and when i turned it back on the touch went out.
I put in a different digitizer and nothing, then i a different motherboard with my digitizer and the touch worked. It's a problem with motherboard? iphone has been dropped many times but always kept in an otterbox.
評価: 781.3千
1.1千
892
2.3千
JD925, since you digitizer works in a different phone, you can rule that out. Try to restore the iPhone and see if that makes a difference. If not, check all your connectors. Make sure there are no bend, broken or corroded pins. If those are okay, you may have a bad touchscreen IC. Hope this helps, good luck
このアンサーは役に立ちましたか？
It's possible for the touch IC to simply go bad out if no where,???
評価: 37.6千
22
51
42
see does itunes detect it? if it doesent try this
Here's a tutorial with pics that everyone has been requesting. I've used this method over a dozen times successfully. Good Luck!!
There are 3 small battery terminals (shown below). You only want to touch the one to the far right (circled below). Avoid touching the other 2 terminals!!
see the pics
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 4,770
