修理を始めるには コミュニティ ストア

Non-Unibody, Core Duo & Core 2 Duo Processors

375回答 すべてを表示

オプション

Metal tabs from keyboard came off.

I recently replaced the airport extreme card in my a1261, and as I was disassembling it, three small metal tabs came out. They're angled and are threaded, so I'm guessing that they're what hold the three angled Phillips screws in place. I've pieced them together and it seems they connect at the bottom of the keyboard, at the bottom of the trackpad area.

Now, the only problem is I can't figure out how they attach. I first thought they slid underneath the metal edge, but they don't fit underneath.

If anyone knows of a solution that would be great, otherwise I'm half-tempted to epoxy the stupid things in place.

Here's a photo of the tab (circled in red) and where I think it goes (yellow). http://imgur.com/Gycvk61

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Honestly you're on the right path with the epoxy idea. I've had several of these break off over time and I've always glued them back into place with a strong superglue. I clean off the mounting areas, glue them in place, let them set and then reassemble your MacBook Pro, taking a little extra care to not over tighten those 3 screws in the battery bay.

You're also correct on the placement. I don't recall if the 17" MacBook Pro's have these at an angle or if they are level, but if they are at an angle they should angle down towards the trackpad. Basically the higher part of the angle will be towards the front of the top case and the lowest part will be towards the center of the trackpad.

Good luck!

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

1件のコメント:

They are at an angle. Also I use a very rough sandpaper to scratch the glued contact areas to help create a mechanical lock for the superglue.

さんによる

コメントを追加

回答を追加する

Matthew さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 153