bad contact micro-usb charger attack
looking the micro welds they seems to be all right but they doesn't work...is it possible to weld againg them or it's necessary to change all the part of mother board where the chargar attack is attached?
121048
1 件の回答
最も参考になった回答
評価: 781.4千
1.1千
892
2.3千
Kevin Santi, yes you can reflow the existing solder with a small soldering iron. Test your jack with a multimeter. Plug it in and test on the motherboard contacts, to make sure that you have power on that end. Hope this helps, good luck
このアンサーは役に立ちましたか？
スコア
1
Thank you very much =D
