修理を始めるには コミュニティ ストア

iPhoneの5代目となるiPhone 4S。このデバイスの修理は比較的簡単で、スクリュードライバー、開口ツールと忍耐が必要です。GSM/CDMA / 16, 32, 64 GB / 白と黒

2193回答 すべてを表示

オプション

Back camera doesn't work after screen replacement

I replaced the screen of my iPhone 4S. I've done many before, and I'm good at it, I would like to think.

However, when I tried to go onto the camera it just loads the shutter image and wont go any further. The controls at the bottom flash a few times, and some times it will go back to the apple logo and then onto the lock screen. (Not like a reboot, it only takes about 8 seconds)

I ordered a new camera and replaced it, still the same. I've even swapped it for a one I know works and still the same.

Any ideas?

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

I have seen this once and fixed it by restoring the phone several times, that's all I have to offer and hope you get it fixed, good luck, If this Answer is helpful please remember to return and mark it Accepted.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

Can you expand? How can a hardware issue be repaired by a software method?

さんによる

The way I read your question it sounds like you have ruled out hardware, and your symptoms are the same as the one that I fixed with the restore, unless I'm reading your question wrong,,,, when I was stumped by this I called Apple support and they are who told me to restore, and it did finally work after numerous restores,

さんによる

コメントを追加

オプション

i have the same problem, I've had it for a couple of months now, never found any solution to this. I think it's a motherboard problem, where you connect the camera.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

回答を追加する

Jamie Simpson さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,352