メインコンテンツにスキップ
ヘルプ

オリジナル投稿者: martin ,

テキスト:

I have run into this problem several times myself as well. The only way i have found a way around it is below.

When you replace the Digitiser, there is a slight chance you may have dislodged or removed a very small plastic cover and/or a square piece of foam lining over the sensor. These two parts are crucial to the functionality of the sensor.

Below is a sensor ribbon cable WITH the correct covers

[image|159415]

Below is a sensor ribbon cable WITHOUT the correct covers

[image|159416]

If you don't have your original flex to take the covers off of, then you have pretty much no hope of getting it working again. The only way around this is to replace the entire iPhone through Apple.

If your iPhone is still under warranty then it will be FREE.

If your iPhone is not under warranty then there will be a cost of about $260 for an entire unit replacement.

Hope this helps!

Martin

ステータス:

open