***I have 2 v6 Dysons, 1 MotorBrush*** (or whatever its called). One of the v6's will spin the brush fine, but the other will only spin the brush when its lifted off the carpet. Once the brush touches down on the carpet (i guess when suction is created) it stops spinning.
Here's the crazy part. If I take off the end filter and block off ¾ of the air vent with my hand, then re-trigger the v6, the brush will spin on the carpet. (I guess its reducing the suction?)
***Its the older of the v6's that is having problems spinning the brush***, so maybe there is a bad capacitor or something on the circuit board meaning the brush is pulling too much current??? I am planning to investigate, but has anyone had a similar issue?
''ps. The MotorBrush and both v6's have both been thoroughly cleaned, so dirt build-up is not a cause.''