メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

ヘルプ

オリジナル投稿者: jayeff ,

テキスト:

Hi @harleyjos

''Water and electronics and electricity are not a good mix.The impurities in the water causes corrosion and provides circuit paths for the electricity which were not in the phone’s operating design and could damage the components. The corrosion is ongoing until it has been properly cleaned away''

''Rice does not solve the problems caused by the corrosion'' [https://www.ifixit.com/News/30047/rice-is-for-dinner-not-repair|Rice is for dinner, not repair]

First '''do not try to charge or to turn on your phone''' and then '''remove the battery as soon as possible''' to reduce any further damage

Then you need to dis-assemble the rest of the phone and  clean ''all the affected parts'' using '''Isopropyl Alcohol 99%+''' (available from electronics parts stores) to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is <70% IPA, can contain additives and is not as effective. If you do have to use it, check the label to verify the  amount of IPA. The higher the percentage of IPA the better.

Here is a link that describes the process. [[Electronics Water Damage]]

As always with electronics, especially surface mounted pcb be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board. You will also have to remove any shields that may be covering the CPUs etc as water may have got in under them as well causing corrosion to occur there.

Hopefully after you have done all this the phone ''might'' possibly work correctly again.

Here is the ifixit [[Topic:Samsung Galaxy S6]] guide, which may be of some help.

If this process seems too daunting, take your phone to a reputable, professional mobile phone repair service,  experienced in water damage repair and ask for a quote for a repair.

If you decide to do this, ''do it sooner than later''.

ステータス:

open