メインコンテンツにスキップ
ヘルプ

オリジナル投稿者: Dan ,

テキスト:

This is a common issue in this series! Most of the time its a bad HD SATA cable. You likely swapped out your HDD for a SSD which is good, but the original HDD was a SATA II (3.0 Gb/s) drive and the SSD you put in is a SATA III (6.0 Gb/s) but the original HD cable was only designed to support the slower drive. Apple also has a few issues with the cable as well so you want to make sure you get the newest version. The 2012 model cable is what you want [product|IF163-041-2] and here’s the guide you want to follow [guide|5120]

There are a few tricks here you also want to apply. First you want to place a strip of electricians tape on the uppercase where the cable crosses over to help protect it from the rough aluminum surface and you don’t want to crease the cable as that will also damage it! Instead get an old BIC pen and take the ink straw out using it as a form to roll the bends as it has the correct radius for the corner bends.

Here’s a bit more on the cable issue: [https://beetstech.com/blog/prevent-a1278-mid-2012-hard-drive-cable-failure|Your Hard Drive Cable Is A Ticking Time Bomb]

ステータス:

open