メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

ヘルプ

オリジナル投稿者: jayeff ,

テキスト:

Hi,

As you know water and electronics and electricity are not a good mix.

''The impurities in the water causes corrosion and provides circuit paths for the electricity which were not in the phone's operating design and could damage the components. The corrosion doesn’t stop until it has been cleaned away''

''First '''do not turn on your phone''' and then you need to '''remove the battery as soon as possible''' from the phone'' to minimize further damage.

Then you need to dis-assemble the rest of the phone and  clean ''all the affected parts'' using '''Isopropyl Alcohol 90%+''' (available at electronics parts stores) to remove all traces of corrosion and water. Do not use "rubbing alcohol" as in some cases this is only 70% IPA or less, can contain scents and is not as effective. If you do use it, check the label to verify the  amountof IPA

Here is link that describes the process.

[[Electronics Water Damage]]

As always with electronics, especially surface mounted PCBs be gentle when handling and especially when brushing away the corrosion. You do not want to remove any components from the board.

Hopefully after you have done all this the phone ''might'' possibly work correctly again.

Here is a link to the ifixit guide(s) for repairing your phone.

[[Topic:Xiaomi Mi 4]]

If this process seems too daunting, take your phone to a reputable, professional phone repair service, experienced in liquid damage repair and ask for a quote for a repair. If you decide to do this, ''do it sooner than later''.

ステータス:

open