メインコンテンツにスキップ
ヘルプ

現在のバージョン作成者: Bhoang ,

タイトル:

unfinished initial warmingSAMSUNG C410 laser printer-no warm up cycle
unfinished initial warmingSAMSUNG C410 laser printer-no warm up cycle

テキスト:

this is a second samsung i bought, after beingit was scarcely used, both printers wouldn’t power upinitialize properly, fatbig led light bar lighted up. i was on this fix it site under forum thread for this device earlier this year, i found people with this similar issue. one user posted a solution and suggested to change out the pcb board, and pointed out a supplier source. i ordered it in, replaced it. the unit powered uppowered, initialized half way and stopped short before completed warming up. ( beforefinished. it didn’t even try to complete cycle throughthrough before, so it is an improvement) due to its not being completely warming up, the computer does not see the printer. i tried all the standard trouble shooting, still not working. i went back to that thread for help on getting the printer fully initialized with the new board i installed, but not a reply or comment. sadly disappointed. wonder if it was a scheme to get us unsuspecting user to purchase a useless piece of crap. maybe i try here and see you all might encounter this issue and hope to salvage the printer and not wasting the additional toner and pcb i installed. tks
this is a second samsung i bought, after beingit was scarcely used, both printers wouldn’t power upinitialize properly, fatbig led light bar lighted up. i was on this fix it site under forum thread for this device earlier this year, i found people with this similar issue. one user posted a solution and suggested to change out the pcb board, and pointed out a supplier source. i ordered it in, replaced it. the unit powered uppowered, initialized half way and stopped short before completed warming up. ( beforefinished. it didn’t even try to complete cycle throughthrough before, so it is an improvement) due to its not being completely warming up, the computer does not see the printer. i tried all the standard trouble shooting, still not working. i went back to that thread for help on getting the printer fully initialized with the new board i installed, but not a reply or comment. sadly disappointed. wonder if it was a scheme to get us unsuspecting user to purchase a useless piece of crap. maybe i try here and see you all might encounter this issue and hope to salvage the printer and not wasting the additional toner and pcb i installed. tks

デバイス:

Samsung C410

ステータス:

open

オリジナル投稿者: Bhoang ,

タイトル:

unfinished initial warming up cycle

テキスト:

this is a second samsung i bought, after being scarcely used, both printers wouldn’t power up properly, fat led light bar lighted up. i was on this fix it site under forum thread for this device earlier this year, i found people with this similar issue. one user posted and suggested to change out the pcb board, and pointed out a supplier source. i ordered it in, replaced it. the unit powered up half way and stopped short before completed warming up. ( before it didn’t even try to cycle through, so it is an improvement) due to its not being completely warming up, the computer does not see the printer. i tried all the standard trouble shooting, still not working. i went back to that thread for help on getting the printer fully initialized with the new board i installed, but not  a reply or comment. sadly disappointed. wonder if it was a scheme to get us unsuspecting user to purchase a useless piece of crap. maybe i try here and see you all might encounter this issue and hope to salvage the printer and not wasting the additional toner and pcb i installed. tks

デバイス:

Samsung C410

ステータス:

open