メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

ヘルプ

オリジナル投稿者: terry32579 ,

テキスト:

20OCT18.  I also had this issue.  I replaced the mother board, then had to replace the water valve.

What is happening ?  The valve is getting hot and it takes too much current to make it energize and stops filling.

To test the:  Turn on your washer with the sanitize setting.  let it run for about 5 minutes then cancel it and run it again.  Mine failed … wait an hour and it fills.  I wasted money on a computer board where it was the valve due to a poor design…

ステータス:

open