メインコンテンツにスキップ
ヘルプ

現在のバージョン作成者: Eigirdas Gedgaudas ,

テキスト:

If on pcb pads is still in place then flux it and drag solder it or shield the plastic part up and with hot air rework stationstation.

And if you are not that lucky, then you will need microscope and lots of patience. Or send me if you located in uk and ill have a look at it free of charge. Just you funding postages both ways ;)
If on pcb pads is still in place then flux it and drag solder it or shield the plastic part up and with hot air rework stationstation.

And if you are not that lucky, then you will need microscope and lots of patience. Or send me if you located in uk and ill have a look at it free of charge. Just you funding postages both ways ;)

ステータス:

open

オリジナル投稿者: Eigirdas Gedgaudas ,

テキスト:

If on pcb pads is still in place then flux it and drag solder it or shield the plastic part up and with hot air rework station

ステータス:

open