メインコンテンツにスキップ
ヘルプ

オリジナル投稿者: Reece ,

テキスト:

Need a hot air station, soldering iron and consumables (good flux, good solder, etc). Grab a schematic and board view for your particular board to see exactly what pad is missing. You can then run a wire to where it needs to go (although if it has been ripped off for example, it is likely a nc pad which has been pulled since they are weaker)

You can't get these new in the UK, this is the connector you need http://www.ebay.com/itm/DDK-FUJIKURA-FLEXIBLE-PRINTED-CIRCUIT-FPC-CONNECTOR-5-PIN-FF14A-5C-R11DL-B-3H-/282383647646?nma=true&si=qIjkPrDlCbxDqyr8CvXOLp1zwqs%253D&orig_cvip=true&rt=nc&_trksid=p2047675.l2557

You can remove this from a donor board by heating the other side of the board (to avoid melting it), if you have a donor board available. I have about 8 donor boards for the 2013-2015 13" boards, let me know if you need the connector and I'll pull one for you, if any are good.

ステータス:

open