メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

ヘルプ

オリジナル投稿者: Russ ,

テキスト:

OMG! This is one of those "little problem, little hammer" solutions, but it worked. I messed with the gear near the sponge on the far left side. Had to do it twice, but it worked. I then ran clean print head, calibrate and the like and it's good as new. All gunked up inside, so I might attempt to clean all of the crap out over the weekend, but at least I'm getting work done. Funny but amazing.

ステータス:

open