メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

ヘルプ

オリジナル投稿者: MaadMaxx ,

テキスト:

Error 1 is usually caused due to a problem in hardware, if your phone worked fine before the update process heating the phone is the only permanent solution.  In some rare cases BGA soldering  dries up or cracks if your device had survived a fall. To do this you need to open up the phone, remove the motherboard and heat  it up using a rework station, this is a very risky process,  you should heat it to an extent where you don't melt the BGA completely but enough to reattach the connection to the board. If you heat it too much you you will melt the BGA completely and will have a dead device. I have tried this and resurrected many iPhones with error 1. Its best you don't do this your self instead take it to technician.

ステータス:

open