メインコンテンツにスキップ
ヘルプ

オリジナル投稿者: jessabethany ,

テキスト:

You can attach the DC power supply to the battery connector.  Just use multimeter to figure out which pin is gnd--(continuity with gnd shield on board).  Attach negative lead to gnd pin, and positive pin to the outermost pin on other side.  Apply 3.8V.  Start iPad via power button (for mini this requires a functional solder joint at home button flex).

A healthy mini will consume something like 100-300 mAmps of current.  Too low = something on board is closed that should be open.  Too high = something on board is open that should be closed = short.

good luck!

jessa

ステータス:

open