Skip to main content
ヘルプ

オリジナル投稿者: oldturkey03 ,

テキスト:

Jovan Joiner, since you mentioned that " only the sides where doing this " I would assume that your digitizer circuit has failed. You will have to replace the front assembly. Here is the [guide|3639|guide for it] and the part is available [product|IF146-000|right here] as well as many other places. Of course you also want to make sure that it is properly connected and the the connector as well as the logic board are properly seated. Ultimately I think that it is your digitizer. Hope this helps, good luck.

ステータス:

open